The Changan Ruixing M90 decision is mainly roof clearance, rear-door access and the seating layout you actually need. The current Chinese table lists 1,990/2,200 mm exterior heights and several seat and door entries, but does not establish every possible combination. The older source below is a static show-car preview, so ride comfort and working fuel consumption remain unverified. Measure the complete offered van and its loading route before ordering.
Sources checked 24 October 2026. I Auto Export commercially sources vehicles. This is a specification and access analysis using the current Chinese manufacturer page and a dated on-site preview. We have not independently tested ride comfort, loaded braking, fuel consumption, winter use or long-term reliability.
Identify the roof and seating combination
Kaicene’s current M90 table lists petrol Basic: 5,180 × 1,744 × 1,990/2,200 mm, 3,250 mm wheelbase, liftgate/split rear doors and two/six/seven/nine seats. The LJ481Q6 2.0-litre engine is listed at 103 kW/195 Nm with a five-speed manual. The combined rows do not identify every orderable roof/door/seat combination.
Ask the supplier to identify the exact derivative and show its doors, roof and seat labels in one record. Request the applicable documents for that vehicle. Do not read a slash-separated catalogue row as proof that every seat count is available with every roof and door. A conversion proposal also needs its own documented specification.
For a constrained entrance, measure the actual vehicle in its delivered condition and the clearance through the whole approach. Include any fitted roof accessories in the inspection. Keep building clearance separate from interior standing or loading room. An external height figure alone does not show whether a person can work comfortably inside or a tall object can pass through the door.
What does the early on-site preview establish?
CNTPlus’s original 11 June 2016 Chongqing motor-show inspection showed a split-door M90 and discussed high- and low-roof alternatives. It was a static show-car report, not a road test. Its older engine and consumption figures do not describe the current LJ481Q6 specification, nor prove ride comfort or working fuel costs.
Use the door photographs to frame a practical access trial. At the normal unloading location, open the doors fully enough for the intended task and check the space alongside and behind the van. Try the equipment or containers that actually pass through the opening. Photograph the entire path, including the step and internal obstructions, rather than just an empty doorway.
A passenger operation needs a different demonstration. Try entry and exit with the intended seating installed, then sit in each row with the ordinary luggage aboard. Check belt access and the movement needed to reach the rear seats. Do not infer the delivered seats’ adjustment from an older exhibition vehicle or from a picture of another grade.
Choose passenger capacity around the whole trip
Write down the maximum ordinary passenger group and the luggage that travels with it. Assess them together. Extra places are not useful if the remaining luggage arrangement obstructs access or cannot be secured appropriately. Have the proposed layout reconciled with the vehicle documents before treating it as a usable passenger specification.
During a supervised representative drive, ask occupants in different rows to assess seating and movement over the roads you use. Record load, route and conditions. A static walkaround cannot establish rear-row comfort over an entire shift. For a used example, inspect the delivered seat and door fittings and obtain maintenance evidence; appearance alone cannot establish remaining service life.
For sourcing, start with the M90 model page. Send a request with destination city, required seats, luggage or cargo, entrance measurements and unloading method. Ask the supplier to confirm the complete body configuration before quoting optional equipment or operating costs.
